Taking into consideration you’ve already followed Teaching Techs first video of the MKS controller board swap, this upgrade is plug and play!
Want to upgrade your Ender 3s extruder to a metal one? Look no further!
Follow our guide located in our forums on installing OctoPrint-TFT
Teaching Tech shows us how to upgrade the Creality Ender 3 to a direct drive feed for only $35!
no firmware upgrades and no additional wiring.
Before you assemble your Creality Ender 3, watch this video!
I toyed abit more with PinkyPi last night and printed out a slightly modified case as well as started to mix some colors from my 3D printer.
Check out the progress in our forums!
With a typical blend of 70% polymer and 30% wood fibers, these exotic filaments will push your printers capabilities.
Have you printed anything with wood filament? What brand did you use and what were your settings?
I made just a couple very small changes to the case layout for PinkyPi 1.1, a small groove to line up the sections abit better and closing up the micro USB and HDMI ports a little.
I do still want to do some more design to the inside of the base, to hold the battery charging module firmly in place, another notch or two to help secure the layers / sections together, some possible bracing in the middle layer and a possible redesign of the A and B buttons.