Forum

What was the issue

To be honest, I haven't touched the MAME portion yet, I'll look at it tonight.What MAME folder did you drop your ROMs in, I want to make sure I'm foll...

Welcome and glad to have you! After long internal debate, I did decide to provide the files for free on Thingiverse once they are complete (hopefully ...

I'm looking into pulling the bottom back about 3mm - 3.5mm so its not so boxy, but gaining access to the USB port and HDMI port look to be a pain with...

How long do you run it in 1 sitting? 30minutes? An hour, or more/less.

This has been tabled for some time due to PinkyPi, PinkyPi Pro and now PinkyPi X.I plan on starting back into this project in the next couple of weeks...

I'm looking at this and may possibly tackle it once I get further with the case design.Down Mixing Stereo to Mono Raspberry Pi This may be a good solu...

Also, version 1.0 of the PinkyPi X build is up for download (updated 8-31-19 to version 1.1) Download here

I'm going to run a test print of the power switch after work tomorrow and see how well it functions. I did get the basic size of the volume wheel fig...

Opinions? I guess I will have to see what it looks like once printed. I still am hoping to upload build 1.0 of the PinkyPi X image for GamePi15 t...

It may be worth sending an email to Waveshare support at this point.It could be a bad battery, or possibly getting shorted out while in use?

It will likely be in the range of $10-$15 for a premade 3D printed case and buttons if you buy one from us.As for sharing the files on Thingieverse, I...

Good news! Sounds like the Zero's you got from the 3rd party vendor may have been the issue =( On a lighter note, the case is getting very close, I ...

I did do a dry run in Sketchup with some smoothing out, I'm some what happy with it thus far. Very close, yet still a few important items to go!

A few minor changes and another test print.I've gotta extend the height of the base by about 1mm. I also think I'm going to move the charging LED cut...