Last seen: Jun 23, 2024
After some back and forth, I was able to get ChatGPT to provide the following I have tested this code and it seems to work very well. I am also wo...
Great update! Thank you!We have received your order and will be getting it ready for shipping today. Thank you!
Awesome! I am glad to hear you got it working, now the fun begins! =)
Yes from our guides section country=US ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev update_config=1 # RETROPIE CONFIG START ...
If you re-flash the image to the SD card, and try again from your PC by creating the wpa_supplicant.conf in the boot folder, before using it in your P...
If you can hook a keyboard and display up to it, you should be able to use nano (editor) to modify the wpa_supplicant file sudo nano /etc/wpa_su...
Can you share what you have in your wpa-supplicant? It should be located in /etc/wpa_supplicant/wpa_supplicant.conf Make sure to remove your...
I would try a default Raspberry Pi image with the Pi hooked directly up to a monitor over HDMI.This will tell you if there is something wrong with the...
Interesting, I've had a similar problem once, it ended up being a corrupt install on my SD so a re-flash fixed it. But sounds like you've already do...
Awesome! That's great news, I'm glad you got it worked out! Thank you for the follow up
To change the default emulator, you can do so in the runcommand As for the controls, you have to configure these. They will not work right out of th...
Download PuTtY The host name you want to use should just be retropi , you may need to check your router or the Pi itself to see what IP address it h...
I just ran through the process on a fresh SD card with PinkyPi X 1.1 flashed to it.Instead of using the menu, I used Putty to SSH into the device over...