Last seen: Jul 24, 2025
Have you tried the following? Basic ConfigurationThe basic configuration is handled via environment variables, if you are using the .deb package you...
Looks like I may need to come down about .5mm to get everything just right (Also looks like I need to tighten my belts and bolts around my printer lol...
Let us know if you have any issues with a new Raspberry Pi, I haven't seen any other reports of failures and I hoping for some level of confidence tha...
Thank you! And with that this project is complete!Focus is now on the new GamePi15 device to complete the Pinky Pi family
Yeah, that may warrant a support email to WaveShare as well, if the same GamePi15 is frying devices it may be a bad board.I've got 3 GamePi15 hat's, I...
I may end up doing more later tonight, but here is where I've paused thus far. The directional buttons are done, though the more I look at it... I m...
I finally added the start/select buttons while on Lunch today, last item is the HotKey button "flap". But again, the flap itself will be integrated in...
Mine gets warm as well, thats the nature of the Pi. But I haven't had one fail yet with the Gamepi15. On a side note, I did print a case build of th...
I've also got a rounded version of the top half on the printer now. I think tomorrow after work, I'm going to finish the start/select buttons finally,...
I printed out some test buttons for ABXY earlier today, and I've been toying around with some game play, swapping between the 2 different D-Pad styles...
For the larger D-Pad, it was more for general consumers. I think the small one feels fine, but different sized hands and play styles etc... I wanted t...
I haven't had issues with mine yet, though I haven't had it powered on much.What battery are you using?
I'm kinda toying around with 2 D-Pad designs, keeping in mind having to 3D print them. Design 1, is just a concave small D-Pad Design 2, is a 2 part D...
I did make some case updates last night, I wont be printing this till over the weekend once I finish the general design. Again, nothing is rounded of ...
Ewww, I was hoping it would be Mono =(The first case design I'm doing my best to make it plug and play, with out having to modify hardware. I'm more t...