Taking into consideration you’ve already followed Teaching Techs first video of the MKS controller board swap, this upgrade is plug and play!
CrackedConsole
Ender 3 – Metal Extruder Upgrade
Want to upgrade your Ender 3s extruder to a metal one? Look no further!
Custom hand made key caps by GalaxKey
My partner has a great selection of hand-made custom keyboard keycaps, be sure to check him out on Etsy and instagram!
Installing OctoPrint-TFT to control your 3D printer!
Follow our guide located in our forums on installing OctoPrint-TFT
Installing OctoPrint-TFT
Upgrade your Ender 3 to direct drive for only $35!
Teaching Tech shows us how to upgrade the Creality Ender 3 to a direct drive feed for only $35!
no firmware upgrades and no additional wiring.
Ender 3, pro build tips!
Before you assemble your Creality Ender 3, watch this video!
PinkyPi v1.1b – New Cases
I toyed abit more with PinkyPi last night and printed out a slightly modified case as well as started to mix some colors from my 3D printer.
Check out the progress in our forums!
3D Printing with wood filament?
With a typical blend of 70% polymer and 30% wood fibers, these exotic filaments will push your printers capabilities.
Have you printed anything with wood filament? What brand did you use and what were your settings?
PinkyPi 1.1 is on the hot bed!
I made just a couple very small changes to the case layout for PinkyPi 1.1, a small groove to line up the sections abit better and closing up the micro USB and HDMI ports a little.
I do still want to do some more design to the inside of the base, to hold the battery charging module firmly in place, another notch or two to help secure the layers / sections together, some possible bracing in the middle layer and a possible redesign of the A and B buttons.