Forum

Here is what is completed thus far; Factory image tested with me troublesome start button device, start would still fail.I then swapped to my second s...

PinkyPi version 2.6 has been uploaded to Thingiverse and is now live! Download Here

Coming this weekend; The "final" release of PinkyPi on Thingiverse and marking that module "complete". Version 2.6 with the following updates / change...

Just a Pre-Weekend update. This weekend I will be doing the following; PinkyPi Pro specific Assembling the audio circuit / charging circuit and design...

cmake -DST7789VW=ON -DGPIO_TFT_DATA_CONTROL=22 -DGPIO_TFT_RESET_PIN=27 -DDMA_TX_CHANNEL=9 -DDMA_RX_CHANNEL=2 -DSPI_BUS_CLOCK_DIVISOR=6 -DDISPLAY_ROTAT...

I do seem to be running into an issue I'm troubleshooting currently.I can't tell right away if its hardware or software, but the start button just cea...

Below is the build commands I am currently using with RetroPie to get the display driver working cd ~ sudo apt-get install cmake git clone cd fbcp-i...

A quick update for PinkyPi Standard. I've updated the top of the case very slightly to accommodate the slop in the manufactured display boards, this...

Just a quick update, using this command directive during the driver make process, I am able to get video with the improved fbcp-ili9431 driver. I am s...

Madz, welcome and nice to have you! The link above is actually the first route I went, I first installed their drivers on a RetroPie build, and the ...

Hello and welcome, nice to have you. For the miniboy image,I'm guessing when it was created, the author didn't exclude empty blocks maybe? I'm still w...

Still no joy on the driver, I've found where some users have luck with the ST7789VW setting during the make of fbcp-ili9341, so I've tried both the ST...

I've gotten word back from the manufacture, per Spotpear the IC is in fact a ST7789 and the DC and RST pins are in fact DC = 22 and RST = 27 (Pi BCM P...

The Pro build has been moved to PinkyPi Pro Build I'm currently dealing with the display driver as the FPS is very low and I am looking to get the fb...

I've got the case printed out in Grey, and I'm awaiting 2 shades of purple so I can mimic the US SNES Style joystick once the colors arrive. Sadly I d...