Forum

My main focus is an un-modified version. Once complete I may follow up and make a modified version in line with what @donannis is doing with his GameP...

I haven't used it myself, but came across these few articles. I'm gonna run through them and see if I can figure more out about it. I don't have a ...

In the test fit, the buttons feel pretty good. I'm still tossing around ideas for a D-Pad design, I think I'm going to add a middle support so you can...

I've got a rough draft on the printer now for the full case. No rounded corners, no triggers or hot key button, just a few alignment holes and some te...

I need some design feedback as I'm laying this all out...1. Should I used "trigger flaps" such as with the PinkyPi Pro build for the L/R triggers (sli...

Nice build!What batteries are you looking at? I used a 502248 and it fit just right between the pin header and trigger buttons.

I wound up ordering the following batteries, sadly their delivery time is a couple of weeks out.EBL Rechargeable Batteries Lithium-ion 3.7V14500 Recha...

I Think I may have found the same video,And I also found another starter channel running the Gamepi15 and PinkyPi images, I love seeing this kind of s...

For the screen to come up, your printer has to be in "Connected" mode from the WebUI. Octoprint-TTFT Issue #32 Login to your WebUI and verify the prin...

Cutting and editing is done, I should have the Voice over done tonight or tomorrow night at the latest. Sorry for the delay, its been a hectic few mon...

I had to run all my shot footage through HandBreak to re-encode them for my video editing software, with 4k videos that took 2 days. All video for the...

The front page (post 1) has been updated with build instructions. I will be cleaning these up abit and adding more detail this weekend. But this is al...

Some final pics Power and Reset buttons work, fan is install and blowing away. Time to put a nail in it and let it collect dust on my shelf 😉