Last seen: Aug 26, 2019
How long are you using them before they fry, like minutes? or hours?
Looking fantastic so far.. 😉
Honestly, have you been using the same GamePi15 for each of these Pi zeros or swapped with another one.. you might have gotten a bad one, i'd stop con...
I'm super impressed, that came out really nicely. I'll print up the top half when you release 😉 Also, I have them super close together without any h...
Just finished 2 with artwork: [img/p> [img/p>
how does the smaller D-pad feel for movement, is it difficult to move around, and that's why you made it bigger? Also, I make a suggestion to people ...
So, when you do the modified version, this is the layout I went with, speaker on the inside wedged between the gamepi15 and the pi, I jumpered the vo...
I'd indent the bottom honestly, as it would be easier to plug in HDMI, as well as easier to hold.
lol, I just removed it and bridged the 2 solder joints.. I used the volume control in Retropie. also, the little speaker is right channel, not even mo...
Oh man, that looks great so far.. also, did you notice the volume knob has a little slit in the center of it, possible to print out a extended knob an...
Thank you, I have a mountain of arcade/3d printed arcade stuff videos on my channel 😉 www.youtube.com/donannis
So, here is where i am so far need a smaller battery.. lol
So, off topic, but I ended up using just the speaker, I didn't use the huge audio knob, I just wired it at full blast, as I was able to change the vol...
Check out the 102050 battery, that's what I ended up getting.
Please make the pi ports accessable.. 😉